|
Product Details:
Contact Now
Chat Now
|
| Resistance Range: | 1/4W, 1/2W, 1W, 2W, 3W ,5W ,7W ,10W | Rated Power: | 0.1Ω~680KΩ |
|---|---|---|---|
| Tolerance: | ±1%,±2%,±5% | Temperature Coefficient: | ±350PPM/℃ |
| Color: | Grey, Pink , Green | HS Code: | 8533219000 |
| Highlight: | Pink Metal Oxide Resistor,Green Metal Oxide Resistor,3W 390 Ohm Resistor |
||
Product Details
The metal oxide film (MOF) is mostly produced with chemical deposition methods. Almost always a ceramic carrier is used as substrate. The deposition process involves the reaction of a pure metal with a gas at high temperature and at a low pressure. A very common metal oxide film is tin oxide. The film is established by heating the resistor body in a tin chloride vapor. Other metal oxide films have usually a different deposition process. Firstly a thin metal film is applied, which is afterwards reacted with oxygen. The desired composition is achieved by measuring the resistance of a test piece.After the film is applied to the resistor body, the final resistance value is achieved by applying a helical cut. This is usually done by laser cutting, while in the past it was done by grinding or sandblasting. The spiral cut makes the resistance path longer and of smaller cross section, and can increase the resistance value up to thousand times greater than before the cut. The resistance value can be accurately controlled by the cutting. During the cutting process, the resistance is measured to allow for small corrections.
Introduction
| 1. High wattage. | |
| 2. High stability, good reliability. | |
| 3. Flame proof painting. | |
| 4. Non-inductive type is available. | |
| 5. Ultra-low inductance less than 1uH. |
Product mix
| Power Rating | R | R | V | |
| 0.5W | 1WS | 0.2R~1.99R | 2R~4M7 | 300V |
| 1W | 2WS | 0.2R~1.99R | 2R~4M7 | 350V |
| 2W | 3WS | 0.2R~1.99R | 2R~4M7 | 350V |
| 3W | 5WS | 0.2R~1.99R | 2R~4M7 | 400V |
| 5W | 0.2R~1.99R | 2R~4M7 | 400V | |
Metal oxide films 1W 2W 3W Metal oxide films as resistive materials offer high electrical resistance, corrosion resistance, insulation properties, and stable temperature performance. They form a durable barrier, limiting current flow and providing effective protection. With low conductivity, they resist humidity, chemicals, and environmental factors, making them suitable for various electronic and decorative applications.
Contact Person: Mr. Jim
Tel: 15361036926