|
Product Details:
Contact Now
Chat Now
|
| Product Name: | Metal Oxide Film Resistors | Application: | Consumer Electronics, Household Appliances, Power Supplies |
|---|---|---|---|
| Shape: | Cylinder | Resistance Range: | 0.1r~22mr |
| Rated Temperature Rise: | 375 ° C | Specification: | 3*9MM |
| Tolerances: | 5% 10% | Ambient Temperature: | -55 ° C + 125 ° C |
| Highlight: | High Precision Metal Oxide Film Resistors,Metal Oxide Film Resistors 1/2W,3W Cylinder Resistor |
||
Metal Oxide Film Resistors 1/4W 1/2W 1W 2W 3W Iron Wire
Product Details
The metal film resistor is a resistor that forms a resistive film layer on a ceramic or glass substrate by using a special metal or alloy as a resistive material by vacuum evaporation or sputtering. Such resistors are generally produced by a vacuum evaporation process in which the alloy is heated in a vacuum and the alloy is evaporated to form a conductive metal film on the surface of the ceramic rod. The groove can be changed by changing the thickness of the metal film. Its heat resistance, noise potential, temperature coefficient, voltage coefficient and other electrical properties are superior to carbon film resistors. The manufacturing process of the metal film resistor is relatively flexible, and not only the material composition and the film thickness thereof can be adjusted, but also the resistance can be adjusted by the groove, so that a resistor having a good performance and a wide resistance range can be obtained.
Introduction
| 1. Excellent high frequency characteristic | |
| 2. Long term stability | |
| 3. Low TCR | |
| 4. High precision,high stability | |
| 5. Blue or green flame-retardant coating colour code | |
| 6. Taping reel or bulk |
Product mix
| Watts | Dimensions(mm) | ||||||
| L | P±1.0 | D | d±0.03 | h±1.0 | H±1.0 | Emax | |
| 1/4W/1/2WS | 6.0±0.5 | 6 | 2.3±0.3 | 0.4 | 5.0 | 14 | 3 |
| 1/2W/1WS | 9.0±0.5 | 6 | 3.2±0.3 | 0.5 | 5.0 | 18 | 3.5 |
| 1W/2WS | 11.0±1.0 | 6 | 4.0±0.5 | 0.6 | 5.0 | 20 | 3.5 |
| 2W/3WS | 15.0±1.0 | 6 | 5.0±0.5 | 0.7 | 5.0 | 25 | 3.5 |
| 3W/5WS | 17.0±1.0 | 6 | 6.0±0.5 | 0.7 | 5.0 | 30 | 3.5 |
Construction
After the film is applied to the resistor body, the final resistance value is achieved by applying a helical cut. This is usually done by laser cutting, while in the past it was done by grinding or sandblasting. The spiral cut makes the resistance path longer and of smaller cross section, and can increase the resistance value up to thousand times greater than before the cut. The resistance value can be accurately controlled by the cutting. During the cutting process, the resistance is measured to allow for small corrections.
Contact Person: Mr. Jim
Tel: 15361036926