|
Product Details:
Contact Now
Chat Now
|
| Product Name: | Metal Oxide Film Resistor | Application: | Consumer Electronics, Household Appliances, Power Supplies |
|---|---|---|---|
| Resistance Range: | 3r1-10m | Quantity: | Single Connection |
| Tolerances: | ±1% ±5% | Specification: | 2W |
| Origin: | China | ||
| Highlight: | 3r1 MOF Resistor,10m MOF Resistor,Heat Resistant 2W Metal Film Resistor |
||
2W 3r1-10m Metal Oxide Film Resistor With Braid
Product Details
Our metal oxide film resistors offer stable performance, reliable tolerance, and excellent cost efficiency, making them ideal for general-purpose electronic circuits. Constructed on a high-quality ceramic core with a metal oxide film coating, these resistors provide good heat resistance and long-term stability.
Introduction
| 1. Stable Performance: Offers reliable tolerance and excellent cost efficiency for general-purpose circuits. | |
| 2. Wide Power Range: Available in 1/6W to 5W ratings to suit various application needs. | |
| 3. High Heat Resistance: Constructed on ceramic core with metal oxide film for long-term stability. | |
| 4. Automated Assembly Ready: Suitable for both manual assembly and automated production lines. |
Product mix
| Watts | Dimensions(mm) | ||||||
| L | P±1.0 | D | d±0.03 | h±1.0 | H±1.0 | Emax | |
| 1/4W/1/2WS | 6.0±0.5 | 6 | 2.3±0.3 | 0.4 | 5.0 | 14 | 3 |
| 1/2W/1WS | 9.0±0.5 | 6 | 3.2±0.3 | 0.5 | 5.0 | 18 | 3.5 |
| 1W/2WS | 11.0±1.0 | 6 | 4.0±0.5 | 0.6 | 5.0 | 20 | 3.5 |
| 2W/3WS | 15.0±1.0 | 6 | 5.0±0.5 | 0.7 | 5.0 | 25 | 3.5 |
| 3W/5WS | 17.0±1.0 | 6 | 6.0±0.5 | 0.7 | 5.0 | 30 | 3.5 |
Construction
The metal oxide film (MOF) is mostly produced with chemical deposition methods. Almost always a ceramic carrier is used as substrate. The deposition process involves the reaction of a pure metal with a gas at high temperature and at a low pressure. A very common metal oxide film is tin oxide. The film is established by heating the resistor body in a tin chloride vapor. Other metal oxide films have usually a different deposition process. Firstly a thin metal film is applied, which is afterwards reacted with oxygen. The desired composition is achieved by measuring the resistance of a test piece.
After the film is applied to the resistor body, the final resistance value is achieved by applying a helical cut. This is usually done by laser cutting, while in the past it was done by grinding or sandblasting. The spiral cut makes the resistance path longer and of smaller cross section, and can increase the resistance value up to thousand times greater than before the cut. The resistance value can be accurately controlled by the cutting. During the cutting process, the resistance is measured to allow for small corrections.
Contact Person: Mr. Jim
Tel: 15361036926